I have a Dell R610 with a H200i (LSI SAS2008) controller in JBOD mode. Under 11.0 the mps driver would always error on the enclosure: mps0: <Avago Technologies (LSI) SAS2008> port 0xfc00-0xfcff mem 0xdf2b0000-0xdf2bffff,0xdf2c0000-0xdf2fffff irq 16 at device 0.0 on pci3 mps0: Firmware: 07.15.08.00, Driver: 20.00.00.00-fbsd mps0: IOCCapabilities: 185c<ScsiTaskFull,DiagTrace,SnapBuf,EEDP,TransRetry,IR> failure at /usr/src/sys/dev/mps/mps_sas_lsi.c:675/mpssas_add_device()! Could not get ID for device with handle 0x0009 mpssas_fw_work: failed to add device with handle 0x9 da0 at mps0 bus 0 scbus0 target 3 lun 0 da2 at mps0 bus 0 scbus0 target 5 lun 0 da1 at mps0 bus 0 scbus0 target 4 lun 0 da5 at mps0 bus 0 scbus0 target 8 lun 0 da4 at mps0 bus 0 scbus0 target 7 lun 0 da3 at mps0 bus 0 scbus0 target 6 lun 0 After upgrading to 11.1 the mps driver appears to be masking the last hard drive with target=8 and so the system no longer detects the sixth hard drive (da5). mps0: <Avago Technologies (LSI) SAS2008> port 0xfc00-0xfcff mem 0xdf2b0000-0xdf2bffff,0xdf2c0000-0xdf2fffff irq 16 at device 0.0 on pci5 mps0: Firmware: 07.15.08.00, Driver: 21.02.00.00-fbsd mps0: IOCCapabilities: 185c<ScsiTaskFull,DiagTrace,SnapBuf,EEDP,TransRetry,IR> ses0 at mps0 bus 0 scbus0 target 8 lun 0 da2 at mps0 bus 0 scbus0 target 5 lun 0 da3 at mps0 bus 0 scbus0 target 6 lun 0 da1 at mps0 bus 0 scbus0 target 4 lun 0 da4 at mps0 bus 0 scbus0 target 7 lun 0 da0 at mps0 bus 0 scbus0 target 3 lun 0
Has this problem been resolved by now?