When I plug my ScanJet 4300C to the USB port I get this # dmesg uscanner1: vendor 0x03f0 product 0x0305, rev 1.00/0.00, addr 2 uscanner1: setting config no failed device_attach: uscanner1 attach returned 6 uhub0: port 2, set config at addr 2 failed uhub0: device problem (STALLED), disabling port 2 Fix: This is no vital problem, since I can boot into Windows and run my ScanJet there. But if there is no fix, the ScanJet 4300C should be taken out of the list of supported hardware.
State Changed From-To: open->suspended Mark suspended awaiting patches.
Just a small follow-up: The ScanJet 4300C *still* doesn't work with an up-to-date 7-stable. Same dmesg messages. Since this is a long-standing problem and it doesn't seem to be fixed anytime soon, I *strongly* recommend that the ScanJet 4300C entry should be removed from the uscanner(4) manual page, or marked as "currently broken" or similar, so people don't go buy that scanner, believing that it will work because it's explicitely listed in the manpage, like I did. :-( Best regards Oliver PS: From my reading of the code, the problem is not in uscanner(4) but rather in the non-device-specific USB bus code. It seems to disable the port before it ever reaches uscanner's attach function. However, I'm not a USB expert, so I can't tell for sure. -- Oliver Fromme, secnetix GmbH & Co. KG, Marktplatz 29, 85567 Grafing b. M. Handelsregister: Registergericht Muenchen, HRA 74606, Geschäftsfuehrung: secnetix Verwaltungsgesellsch. mbH, Handelsregister: Registergericht Mün- chen, HRB 125758, Geschäftsführer: Maik Bachmann, Olaf Erb, Ralf Gebhart FreeBSD-Dienstleistungen, -Produkte und mehr: http://www.secnetix.de/bsd In my experience the term "transparent proxy" is an oxymoron (like jumbo shrimp). "Transparent" proxies seem to vary from the distortions of a funhouse mirror to barely translucent. I really, really dislike them when trying to figure out the corrective lenses needed with each of them. -- R. Kevin Oberman, Network Engineer
batch change: For bugs that match the following - Status Is In progress AND - Untouched since 2018-01-01. AND - Affects Base System OR Documentation DO: Reset to open status. Note: I did a quick pass but if you are getting this email it might be worthwhile to double check to see if this bug ought to be closed.