I use laptop HP Comapaq nc6320 1) sleep S4 and S3 crash the system: FreeBSD go to sleep, but don't wake up! 2) Permanent I got following message (very frequently, one per minute) acpi_tz0: _CRT value is absurd, ignored (256.0C) 3) When I use two battery at the same time and boot FreeBSD without power, primary battery produce wrong Remaining time (about 23 hour), but secondary get a right value: % acpiconf -i0 | grep "^Remaining time:" Remaining time: 23:00 % acpiconf -i1 | grep "^Remaining time:" Remaining time: 4:30 ..but if I boot system whith power plugged in and after the booting detach power, all be Ok: % acpiconf -i0 | grep "^Remaining time:" Remaining time: 2:17 % acpiconf -i1 | grep "^Remaining time:" Remaining time: 4:30 How-To-Repeat: Just install FreeBSD 6.2 BETA2 or FreeBSD CURRENT on HP Compaq nc6320 :)
Responsible Changed From-To: freebsd-bugs->freebsd-acpi Over to maintainer(s).
Is this still an issue? -- Andriy Gapon
I use laptop HP Compaq 530 and run 8.2-RELEASE and have the first two problems. I don't know whether the third problem exists, not using two batteries.
This is still an issue on HP 530 Laptop. I am willing to debug it. Just = point me where to start.
Responsible Changed From-To: freebsd-acpi->hiren Grab.
No time and no hardware.
batch change: For bugs that match the following - Status Is In progress AND - Untouched since 2018-01-01. AND - Affects Base System OR Documentation DO: Reset to open status. Note: I did a quick pass but if you are getting this email it might be worthwhile to double check to see if this bug ought to be closed.