With or without HALD running, with dbus running, using a USB mouse or USB keyboard, the USB device persistently disconnects and reconnects about every minute.
Note that this only occurs in console mode. Moused is not enabled. When using moused (/etc/rc.conf) with X11/xorg, there were still serious mouse disconnection issues. Using no moused and configuring X11/xorg to use "/dev/usm0" only as its "pointer device", appears to have cleared up the previously noted X11/xorg mouse disconnection problem, but the console disconnects still occur for USB mouse or USB keyboard. On 12/25/12 00:20, FreeBSD-gnats-submit@FreeBSD.org wrote: > Thank you very much for your problem report. > It has the internal identification `usb/174695'. > The individual assigned to look at your > report is: freebsd-usb. > > You can access the state of your problem report at any time > via this link: > > http://www.freebsd.org/cgi/query-pr.cgi?pr=174695 > >> Category: usb >> Responsible: freebsd-usb >> Synopsis: usb keeps disconnecting mouse or keyboard >> Arrival-Date: Tue Dec 25 06:20:00 UTC 2012
On Tuesday 25 December 2012 09:45:55 FreeBSD Proponent wrote: > Note that this only occurs in console mode. Moused is not enabled. > When using moused (/etc/rc.conf) with X11/xorg, there were still serious > mouse disconnection issues. Using no moused and configuring X11/xorg to > use "/dev/usm0" only as its "pointer device", appears to have cleared up > the previously noted X11/xorg mouse disconnection problem, but the > console disconnects still occur for USB mouse or USB keyboard. > Hi, Can you build a 10-current kernel only and install and boot once, and see if the issue is the same. 10-current has backwards compatibility for 8-stable. --HPS
Feedback timeout 3 years plus.
(In reply to hselasky from comment #2) Eventually I will be able to build FBSD-10, but not for a couple of weeks.
Have tested with FBSD-9.3 and FBSD-10.1 Live CD. When in normal console boot mode (run level 3/5) moused is running and there is no interruption as stated before. If moused is NOT running, then there are persistent console interruptions relating to a connected USB mouse. This normally only occurs now when in single user mode. However, I have found that if I start moused in single user mode, then the USB disconnect messages no longer occur. SO - the resolution to my problem is to make sure that moused is running all of the time as I have no choice with the current motherboard of using a PS/2 mouse. You may close this problem. Thanks.