While booting r367891 a panic occurs. See file in URL for dmesg. Kernel config: ----8<---------- include GENERIC ident BNTS-NVS options RATELIMIT # TX rate limiting support options TCPHPTS ----8<----------
This is double of #250351. In both cases it sounds as if fpu_kern_exit() was forgotten. I do not see anything obvious in zfs code.
With today's CURRENT and openzfs (sysutils/openzfs-kmod) I'm getting: nda21: 1526185MB (3125627568 512 byte sectors) Fatal trap 12: page fault while in kernel mode cpuid = 27; apic id = 1b fault virtual address = 0x58 fault code = supervisor read data, page not present instruction pointer = 0x20:0xffffffff80bc1f09 stack pointer = 0x28:0xfffffe01a3f59b80 frame pointer = 0x28:0xfffffe01a3f59bc0 code segment = base rx0, limit 0xfffff, type 0x1b = DPL 0, pres 1, long 1, def32 0, gran 1 processor eflags = interrupt enabled, resume, IOPL = 0 current process = 1 (kernel) trap number = 12 panic: page fault cpuid = 27 time = 115 KDB: stack backtrace: db_trace_self_wrapper() at db_trace_self_wrapper+0x2b/frame 0xfffffe01a3f59830 vpanic() at vpanic+0x181/frame 0xfffffe01a3f59880 panic() at panic+0x43/frame 0xfffffe01a3f598e0 trap_fatal() at trap_fatal+0x387/frame 0xfffffe01a3f59940 trap_pfault() at trap_pfault+0x97/frame 0xfffffe01a3f599a0 trap() at trap+0x2ab/frame 0xfffffe01a3f59ab0 calltrap() at calltrap+0x8/frame 0xfffffe01a3f59ab0 --- trap 0xc, rip = 0xffffffff80bc1f09, rsp = 0xfffffe01a3f59b80, rbp = 0xfffffe01a3f59bc0 --- __mtx_lock_flags() at __mtx_lock_flags+0x49/frame 0xfffffe01a3f59bc0 zone_dataset_visible() at zone_dataset_visible+0x6b/frame 0xfffffe01a3f59c10 zfs_mount() at zfs_mount+0x26c/frame 0xfffffe01a3f59d90 vfs_domount() at vfs_domount+0x89c/frame 0xfffffe01a3f5a000 vfs_donmount() at vfs_donmount+0x872/frame 0xfffffe01a3f5a0a0 kernel_mount() at kernel_mount+0x57/frame 0xfffffe01a3f5a0f0 parse_mount() at parse_mount+0x4a1/frame 0xfffffe01a3f5a230 vfs_mountroot() at vfs_mountroot+0x589/frame 0xfffffe01a3f5a3a0 start_init() at start_init+0x1f/frame 0xfffffe01a3f5a430 fork_exit() at fork_exit+0x80/frame 0xfffffe01a3f5a470 fork_trampoline() at fork_trampoline+0xe/frame 0xfffffe01a3f5a470 --- trap 0, rip = 0, rsp = 0, rbp = 0 --- KDB: enter: panic [ thread pid 1 tid 100002 ] Stopped at kdb_enter+0x37: movq $0,0x10ac246(%rip)
And this is happening on boot.